Showing a Slide Show

Different ways exist to start a slide show. Once a slide show is running, you can take control pressing keys or clicking the mouse buttons.

By default, a slide show always starts with the first slide. You advance manually through slides up to the last slide. You can change these settings.

Running a Slide Show

tip

Press Esc to abort the slide show before its end.


Many more keys are available to control a slide show. You can also right-click to open a context menu with useful commands.

Showing an automatic slide show (kiosk mode)

For an automatic change to the next slide, you must assign a slide transition to each slide.

  1. Open the Slide Transition sidebar deck.

  2. In the Advance Slide area, click After and enter a time duration.

  3. Click Apply Transition to All Slides.

tip

You can assign a different time for every slide to advance to the next slide. The rehearse timings feature can assist you to get the timing right.


To advance to the first slide, after all slides have been shown, you must set the slide show to repeat automatically.

  1. Choose Slide Show - Slide Show Settings.

  2. In the Presentation Mode area, choose Loop and repeat after and set the duration of the pause between shows.

Running a slide show from a file

You can start Collabora Office from a command prompt, followed by the parameter -show and an Impress filename. For example, to start the file filename.odp from the command prompt, enter the following command:

soffice -show filename.odp

This assumes that soffice is in the program path of your system, and that filename.odp is located in the current directory.

Please support us!